Command Manual – QoS
H3C S7500E Series Ethernet Switches Chapter 2 QoS Policy Configuration Commands
2-28
Description
Use the qos policy command to create a policy. This command also leads you to policy
view.
Use the undo qos policy command to remove a policy.
To remove a policy that is currently applied on a port, you need to disable it on the port
first.
Related commands: classifier behavior, qos apply policy.
Examples
# Create a policy named user1.
<Sysname> system-view
[Sysname] qos policy user1
[Sysname-qospolicy-user1]
2.3.9 qos vlan-policy
Syntax
qos vlan-policy policy-name vlan vlan-id-list { inbound | outbound }
undo qos vlan-policy vlan vlan-id-list { inbound | outbound }
View
System view
Parameters
policy-name: Policy name.
vlan-id-list: List of VLAN IDs, presented in the form of vlan-id to vlan-id or discontinuous
VLAN IDs. Up to eight VLAN IDs can be specified at a time.
inbound: Specifies to apply the VLAN policy in the inbound direction of the VLAN.
outbound: Specifies to apply the VLAN policy in the outbound direction of the VLAN.
Description
Use the qos vlan-policy command to apply the VLAN policy to the specific VLAN(s).
Use the undo qos vlan-policy command to remove the VLAN policy from the specific
VLAN(s).
Note that, when you apply a QoS policy with the qos vlan-policy command, support
for the inbound/outbound keyword varies with the actions defined in the traffic
behavior and the type of the LPU to which the ports in the VLAN belong, as described in
Table 2-10.
To Next Page
Loading...
Need help?
General
