Command Manual – Information Center
H3C S7500E Series Ethernet Switches
Chapter 1 Information Center Configuration
Commands
1-29
View
User view
Parameters
None
Description
Use the terminal logging command to enable the display of log information on the
current terminal.
Use the undo terminal logging command to disable the display of log information on
the current terminal.
By default, the display of log information on the current terminal is disabled.
Note that the log information is displayed (using the terminal logging command) only
after the monitoring of system information is enabled on the current terminal first (using
the terminal monitor command).
Examples
# Disable the display of log information on the current terminal.
<Sysname> undo terminal logging
% Current terminal logging is off
1.1.30 terminal monitor
Syntax
terminal monitor
undo terminal monitor
View
User view
Parameters
None
Description
Use the terminal monitor command to enable the monitoring of system information on
the current terminal.
Use the undo terminal monitor command to disable the monitoring of system
information on the current terminal.
z You need to configure the terminal monitor command before you can display the
log, trap, and debugging information.
To Next Page
Loading...
Need help?
General
