To Next Page

To Previous Page

Command Manual – QoS

H3C S7500E Series Ethernet Switches

Chapter 3 Congestion Management Configuration

Commands

3-3

3.1.3 qos sp

Syntax

qos sp

undo qos sp

View

Ethernet interface view, port group view

Parameters

None

Description

Use the qos sp command to configure SP queuing on the current port.

Use the undo qos sp command to restore the default queuing algorithm on the port.

By default, the switch adopts the SP queue-scheduling algorithm.

Related commands: display qos sp interface.

Examples

# Configure SP queuing on Ethernet 2/0/1.

<H3C> system-view

[H3C] interface Ethernet 2/0/1

[H3C-Ethernet2/0/1] qos sp

3.1.4 qos wrr

Syntax

qos wrr queue-id group { sp | group-id weight queue-weight }

undo qos wrr

View

Ethernet interface view, port group view

Parameters

queue-id: ID of the queue, in the range of 0 to 7.

group-id: It can only be 1.

weight schedule-value: Specifies the scheduling weight of a queue, rang from 1 to 15.

sp: Configures SP queuing.

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series