H3C S7500E Series Command Manual

Command Manual – QoS
H3C S7500E Series Ethernet Switches
Chapter 5 Traffic Mirroring Configuration
Commands
5-1
Chapter 5 Traffic Mirroring Configuration
Commands
5.1 Traffic Mirroring Configuration Commands
5.1.1 mirror-to
Syntax
mirror-to { cpu | interface interface-type interface-number }
undo mirror-to { cpu | interface interface-type interface-number }
View
Traffic behavior view
Parameters
cpu: Redirects packets to the CPU.
interface interface-type interface-number: Port type and port number of the destination
port for the traffic mirroring action.
Description
Use the mirror-to command to configure traffic mirroring action for a traffic behavior.
Use the undo mirror-to command to remove the traffic mirroring action.
Note that when the action of mirroring traffic is applied in the outbound direction, any
other action cannot be configured in the same traffic behavior. Otherwise, the
corresponding QoS policy cannot be applied successfully.
Examples
# Configure traffic behavior 1 and define the action of mirroring traffic to Ethernet2/0/2
in the traffic behavior.
<Sysname> system-view
[Sysname] traffic behavior 1
[Sysname-behavior-1] mirror-to interface Ethernet 2/0/2

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English