H3C S7500E Series

Command Manual – DHCP
H3C S7500E Series Ethernet Switches Chapter 3 DHCP Client Configuration Commands
3-1
Chapter 3 DHCP Client Configuration Commands
 Note:
z The DHCP client configuration is supported only on VLAN interfaces.
z When multiple VLAN interfaces having the same MAC address use DHCP for IP
address acquisition via a relay agent, the DHCP server cannot be the Windows
2000 Server or Windows 2003 Server.
z You are not recommended to enable both the DHCP client and the DHCP Snooping
on the same device. Otherwise, DHCP Snooping entries may fail to be generated,
or the DHCP client may fail to obtain an IP address.
3.1 DHCP Client Configuration Commands
3.1.1 display dhcp client
Syntax
display dhcp client [ verbose ] [ interface interface-type interface-number ]
View
Any view
Parameters
verbose: Specifies verbose DHCP client information to be displayed.
interface interface-type interface-number: Specifies an interface of which to display
DHCP client information.
Description
Use the display dhcp client command to display DHCP client information. If no
interface interface-type interface-number is specified, DHCP client information of all
interfaces will be displayed.
Examples
# Display DHCP client information of all interfaces.
<Sysname> display dhcp client
Vlan-interface1 DHCP client information:
Current machine state: BOUND