H3C S7500E Series

Command Manual – IP Routing Overview
H3C S7500E Series Ethernet Switches Chapter 1 Routing Overview Commands
1-2
Table 1-1 Description on the fields of the display ip relay-route command
Field Description
Total Number of Relay-route Total number of recursive routes
Dest/Mask Destination address/mask of the recursive route
Related instance id(s)
The number in the parentheses after each
instance ID indicates the number of routes that
have used the recursive route in the routing table
corresponding to the instance ID.
1.1.2 display ip relay-tunnel
Syntax
display ip relay-tunnel
View
Any view
Parameters
None
Description
Use the display ip relay-tunnel command to display recursive tunnel information.
Examples
# Display recursive tunnel information.
<Sysname> display ip relay-tunnel
Total Number of Relay-tunnel is: 1.
Dest/Mask: 40.40.40.40/255.255.255.255
Related instance id(s): 1(1) 2(1) 3(1) 4(1)
Table 1-2 display ip relay-tunnel command output description
Field Description
Total Number of Relay-tunnel Total number of recursive tunnels
Dest/Mask Destination address/mask of the recursive tunnel
Related instance id(s)
The number in the parentheses after each
instance ID indicates the number of routes that
have used the recursive tunnel in the routing table
corresponding to the instance ID.