H3C S7500E Series

Command Manual – Portal
H3C S7500E Series Ethernet Switches Chapter 1 Portal Configuration Commands
1-1
Chapter 1 Portal Configuration Commands
1.1 Portal Configuration Commands
1.1.1 display portal acl
Syntax
display portal acl { all | dynamic | static } interface interface-type interface-number
View
Any view
Parameters
all: Displays all portal access control lists (ACLs), including dynamic ones and static
ones.
dynamic: Displays dynamic portal ACLs, namely, ACLs generated after a user passes
portal authentication.
static: Displays static portal ACLs, namely, ACLs generated by related configurations.
interface interface-type interface-number: Displays the ACLs on the specified
interface.
Description
Use the display portal acl command to display the ACLs on a specified interface.
Examples
# Display all ACLs on interface Vlan-interface 2.
<Sysname> display portal acl all interface Vlan-interface 2
Vlan-interface 2 portal ACL rule:
Rule 0
Inbound interface = Ethernet2/0/3
Type = static
Action = permit
Source:
IP = 0.0.0.0
Mask = 0.0.0.0
MAC = 0000-0000-0000
Interface = any
VLAN = 2
Destination: