H3C S7500E Series

Command Manual – PoE
H3C S7500E Series Ethernet Switches Chapter 1 PoE Configuration Commands
1-31
Description
Use the poe pd-description command to configure a description for the PD connected
to a PoE interface.
Use the undo poe pd-description command to restore the default.
By default, no description is available for the PD connected to a PoE interface.
Examples
# Configure the description for the PD connected to Ethernet 2/0/2 as IP Phone for
Room 101.
<Sysname> system-view
[Sysname] interface Ethernet 2/0/2
[Sysname-Ethernet2/0/2] poe pd-description IP Phone For Room 101
1.1.25 poe pd-policy priority
Syntax
poe pd-policy priority
undo poe pd-policy priority
View
System view
Parameters
None
Description
Use the poe pd-policy priority command to configure a PD power management
priority policy.
Use the undo poe pd-policy priority command to remove the PD power management
priority policy.
By default, no PD power management priority policy is configured.
Examples
# Configure a PD power management priority policy
<Sysname> system-view
[Sysname] poe pd-policy priority