H3C S7500E Series Command Manual

Command Manual – Information Center
H3C S7500E Series Ethernet Switches
Chapter 1 Information Center Configuration
Commands
1-28
Description
Use the reset trapbuffer command to reset the trap buffer contents.
Examples
# Reset the trap buffer contents.
<Sysname> reset trapbuffer
1.1.28 terminal debugging
Syntax
terminal debugging
undo terminal debugging
View
User view
Parameters
None
Description
Use the terminal debugging command to enable the display of debugging information
on the current terminal.
Use the undo terminal debugging command to disable the display of debugging
information on the current terminal.
By default, the display of debugging information on the current terminal is disabled.
Note that the debugging information is displayed (using the terminal debugging
command) only after the monitoring of system information is enabled on the current
terminal first (using the terminal monitor command).
Examples
# Enable the display of debugging information on the current terminal.
<Sysname> terminal debugging
% Current terminal debugging is on
1.1.29 terminal logging
Syntax
terminal logging
undo terminal logging

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English