H3C S7500E Series

Command Manual – PoE
H3C S7500E Series Ethernet Switches Chapter 1 PoE Configuration Commands
1-35
Examples
# Configure a PSE power management priority policy.
<Sysname> system-view
[Sysname] poe pse-policy priority
1.1.30 poe update
Syntax
poe update { full | refresh } filename [ pse pse-id ]
View
System view
Parameters
full: Specifies to upgrade the PSE processing software in full mode when the software
is unavailable.
refresh: Specifies to upgrade the PSE processing software in refresh mode when the
software is available.
filename: Name of the upgrade file, a string of 1 to 64 characters. This file must be
under the root directory of the file system of the device. The extension of the upgrade
file is .s19.
pse pse-id: Specifies a PSE ID.
Description
Use the poe update command to upgrade the PSE processing software online.
Examples
# Upgrade the processing software of PSE 7 online.
<Sysname> system-view
[Sysname] poe update refresh 0400_001.S19 pse 7
1.1.31 poe utilization-threshold
Syntax
poe utilization-threshold utilization-threshold-value [ pse pse-id ]
undo poe utilization-threshold [ pse pse-id ]
View
System view