Command Manual – IP Routing Overview
H3C S7500E Series Ethernet Switches Chapter 1 Routing Overview Commands
1-12
Destination/Mask Proto Pre Cost NextHop Interface
11.1.1.0/24 Static 60 0 0.0.0.0 NULL0
# Display route entries for destination addresses in the range 1.1.1.0 to 5.5.5.0.
<Sysname> display ip routing-table 1.1.1.0 24 5.5.5.0 24
Routing Table : Public
Destination/Mask Proto Pre Cost NextHop Interface
1.1.1.0/24 Direct 0 0 1.1.1.1 Vlan1
1.1.1.1/32 Direct 0 0 127.0.0.1 InLoop0
2.2.2.0/24 Direct 0 0 2.2.2.1 Vlan2
For the description of the command output above, seeTable 1-4.
1.1.6 display ip routing-table ip-prefix
Syntax
display ip routing-table ip-prefix ip-prefix-name [ verbose ]
View
Any view
Parameters
ip-prefix-name: IP Prefix list name, a string of 1 to 19 characters.
verbose: Displays detailed routing table information, including that for inactive routes.
With this argument absent, the command displays only brief information about active
routes.
Description
Use the display ip routing-table ip-prefix command to display information about
routes permitted by a specified prefix list.
This command is intended for the follow-up display of routing policies. If the specified
prefix list is not configured, detailed information about all routes (with the verbose
keyword) or brief information about all active routes (without the verbose keyword) is
displayed.
Examples
# Configure a prefix list named test, permitting routes with a prefix of 2.2.2.0 and a
mask length between 24 and 32.
<Sysname> system-view
[Sysname] ip ip-prefix test permit 2.2.2.0 24 less-equal 32
To Next Page
Loading...
Need help?
General
