Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 4 IPv6 IS-IS Configuration Commands
4-4
Parameters
route-policy-name: Specifies the name of a routing policy with a string of 1 to 19
characters.
level-1: Specifies the default route as Level-1.
level-2: Specifies the default route as Level-2.
level-1-2: Specifies the default route as Level-1-2.
 Note:
If no level is specified, the default route belongs to Level-2.
Description
Use the ipv6 default-route-advertise command to generate a Level-1 or Level-2 IPv6
IS-IS default route.
Use the undo ipv6 default-route-advertise command to disable generating a default
route.
No IPv6 IS-IS default route is generated by default.
With a routing policy, you can configure IPv6 IS-IS to generate the default route that
must match the routing policy. You can use the apply isis level-1 command in routing
policy view to generate a default route in L1 LSPs, or use the apply isis level-2
command in routing policy view to generate a default route in L2 LSPs, and use the
apply isis level-1-2 in routing policy view to generate a default route in L1 and L2 LSPs
respectively.
Examples
# Configure the router to generate a default route in Level-2 LSPs.
<Sysname> system-view
[Sysname] isis
[Sysname-isis-1] ipv6 default-route-advertise
4.1.3 ipv6 enable
Syntax
ipv6 enable
undo ipv6 enable
View
IS-IS view
To Next Page
Loading...
Need help?
General
