H3C S7500E Series

Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 3 IGMP Configuration Commands
3-1
Chapter 3 IGMP Configuration Commands
 Note:
The term “router” in this document refers to a router in a generic sense or a Layer 3
switch running IGMP.
3.1 IGMP Configuration Commands
3.1.1 display igmp group
Syntax
display igmp group [ group-address | interface interface-type interface-number ]
[ static | verbose ]
View
Any view
Parameters
group-address: Multicast group address, in the range of 224.0.1.0 to 239.255.255.255.
interface interface-type interface-number: Displays the IGMP multicast group
information about a particular interface.
static: Displays the information of statically joined IGMP multicast groups
verbose: Displays the detailed information of IGMP multicast groups.
Description
Use the display igmp group command to view IGMP multicast group information.
Note that:
z If you do not specify group-address, this command will display the IGMP
information of all the multicast groups.
z If you do not specify interface-type interface-number, this command will display
the IGMP multicast group information on all the interfaces.
z If you do not specify the static keyword, this command will display the detailed
information about the dynamically joined IGMP multicast groups.