H3C S7500E Series Command Manual

Command Manual – VLAN
H3C S7500E Series Ethernet Switches Chapter 1 VLAN Configuration Commands
1-2
1.1.2 display interface Vlan-interface
Syntax
display interface Vlan-interface [ vlan-interface-id ]
View
Any view
Parameters
vlan-interface-id: VLAN interface ID.
Description
Use the display interface Vlan-interface command to display the relevant information
of a VLAN interface.
Execution of the command with the parameter included will display the information of a
specified VLAN interface; otherwise, information on all created VLAN interfaces will be
displayed.
Related commands: interface Vlan-interface.
Examples
# Display the information of VLAN-interface 2.
<Sysname> display interface vlan-interface 2
Vlan-interface2 current state: UP
Line protocol current state: UP
Description: Vlan-interface2 Interface
The Maximum Transmit Unit is 1500
Internet Address is 192.168.0.72/24 Primary
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 0000-fc00-6505
IPv6 Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 0000-fc00-6505
Table 1-1 Description on the fields of the display interface Vlan-interface command
Field Description
Vlan-interface2 current state The physical state of a VLAN interface
Line protocol current state The link layer protocol state of a VLAN interface
Description The description of a VLAN interface
The Maximum Transmit Unit The MTU of a VLAN interface
Internet protocol processing : IP processing ability
IP Packet Frame Type IPv4 outgoing frame format

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English