H3C S7500E Series Command Manual

Command Manual – DHCP
H3C S7500E Series Ethernet Switches Chapter 4 DHCP Snooping Configuration Commands
4-6
D 10.1.1.1 000f-e200-0006 286 1
GigabitEthernet2/0/1
--- 1 dhcp-snooping item(s) found ---
Table 4-1 Description on fields of the display dhcp snooping command
Field Description
Type Binding type
IP Address IP address assigned to the DHCP client
MAC Address MAC address of the DHCP client
Lease Lease period of the IP address in seconds
VLAN VLAN where the port connecting the DHCP client resides
Interface Port to which the DHCP client is connected
4.1.7 display dhcp-snooping trust
Syntax
display dhcp-snooping trust
View
Any view
Parameters
None
Description
Use the display dhcp-snooping trust command to display information about trusted
ports.
Related commands: dhcp-snooping trust.
Examples
# Display information about trusted ports.
<Sysname> display dhcp-snooping trust
DHCP Snooping is enabled.
DHCP Snooping trust becomes active.
Interface Trusted
========================= ============
GigabitEthernet2/0/1 Trusted
The above output shows that DHCP snooping is enabled, DHCP snooping trust is
active, and port GigabitEthernet 2/0/1 is trusted

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English