Command Manual – DHCP
H3C S7500E Series Ethernet Switches Chapter 1 DHCP Server Configuration Commands
1-1
Chapter 1 DHCP Server Configuration Commands
 Note:
z The DHCP server configuration is supported only on VLAN interfaces and loopback
interfaces. The subaddress pool configuration is not supported on loopback
interfaces.
z DHCP Snooping must be disabled on the DHCP server.
1.1 DHCP Server Configuration Commands
1.1.1 bims-server
Syntax
bims-server ip ip-address [ port port-number ] sharekey key
undo bims-server
View
DHCP address pool view
Parameters
ip ip-address: Specifies an IP address for the BIMS server.
port port-number: Specifies a port number for the BIMS server in the range 1 to 65534.
sharekey key: Specifies a shared key for the BIMS server, which is a string of 1 to 16
characters.
Description
Use the bims-server command to specify the IP address, port number, and shared key
of the BIMS server in the DHCP address pool for the client.
Use the undo bims-server command to remove BIMS server information assigned
from the DHCP address pool to the DHCP client.
By default, no BIMS server information is specified.
If you execute the bims-server command repeatedly, the latest configuration will
overwrite the previous one.
Related commands: dhcp server ip-pool.
To Next Page
Loading...
Need help?
General
