Command Manual – Information Center
H3C S7500E Series Ethernet Switches
Chapter 1 Information Center Configuration
Commands
1-12
<Sysname> system-view
[Sysname] info-center channel 0 name abc
1.1.9 info-center console channel
Syntax
info-center console channel { channel-number | channel-name }
undo info-center console channel
View
System view
Parameters
channel-number: Specifies a channel number, in the range 0 to 9.
channel-name: Specifies a channel name, which could be a default name or a
self-defined name. The user needs to specify a channel name first before using it as a
self-defined channel name. For more information, refer to the info-center channel
name command.
Description
Use the info-center console channel command to specify the channel to output
system information to the console.
Use the undo info-center console channel command to restore the default output
channel to the console.
By default, output of information to the console is enabled with channel 0 as the default
channel (known as console).
Note that the info-center console channel command takes effect only after the
information center is enabled first with the info-center enable command.
Examples
# Set channel 0 to output system information to the console.
<Sysname> system-view
[Sysname] info-center console channel 0
1.1.10 info-center enable
Syntax
info-center enable
undo info-center enable
To Next Page
Loading...
Need help?
General
