H3C S7500E Series Command Manual

Command Manual – DHCP
H3C S7500E Series Ethernet Switches Chapter 1 DHCP Server Configuration Commands
1-3
View
System view
Parameters
None
Description
Use the dhcp enable command to enable DHCP.
Use the undo dhcp enable command to disable DHCP.
By default, DHCP is disabled.
 Note:
You need to enable DHCP before performing DHCP server and relay agent
configurations.
Examples
# Enable DHCP.
<Sysname> system-view
[Sysname] dhcp enable
1.1.4 dhcp select server global-pool
Syntax
dhcp select server global-pool [ subaddress ]
undo dhcp select server global-pool subaddress
View
Interface view
Parameters
subaddress: Supports subaddress allocation. That is, the DHCP server and clients are
on the same network segment, and the server allocates IP addresses from the address
pool containing the network segment of the first subaddress if several subaddresses
exist.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English