H3C S7500E Series Command Manual

Command Manual – Login
H3C S7500E Series Ethernet Switches
Chapter 1 Commands for Logging into an
Ethernet Switch
1-27
View
System view
Parameters
None
Description
Use the telnet client source command to specify the source IP address or source
interface for the Telnet packets to be sent.
Use the undo telnet client source command to remove the source IP address or
source interface configured for Telnet packets.
By default, source IP address or source interface of the Telnet packets sent is not
configured.
Examples
# Specify the source IP address for Telnet packets.
<Sysname> system-view
[Sysname] telnet client source ip 129.102.0.2
# Remove the source IP address configured for Telnet packets.
[Sysname] undo telnet client source
1.1.30 telnet server enable
Syntax
telnet server enable
undo telnet server enable
View
System view
Parameters
None
Description
Use the telnet server enable command to make the switch to operate as a Telnet
Server.
Use the undo telnet server enable command disable the switch from operating as a
Telnet server.
By default, a switch does not operate as a Telnet server.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English