H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 5 BGP Configuration Commands
5-44
Examples
# In BGP view, allow establishing the EBGP connection with the peer group test that is
on an indirectly connected network.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] peer test ebgp-max-hop
5.1.50 peer enable
Syntax
peer ip-address enable
undo peer ip-address enable
View
BGP view
Parameters
ip-address: IP address of a peer.
Description
Use the peer enable command to enable the specified peer.
Use the undo peer enable command to disable the specified peer.
By default, the BGP peer is enabled.
If a peer is disabled, the router will not exchange routing information with the peer.
Examples
# Disable peer 18.10.0.9.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] peer 18.10.0.9 group group1
[Sysname-bgp] undo peer 18.10.0.9 enable
5.1.51 peer fake-as
Syntax
peer { group-name | ip-address } fake-as as-number
undo peer { group-name | ip-address } fake-as
View
BGP view

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English