H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 5 BGP Configuration Commands
5-45
Parameters
group-name: Name of a peer group, a string of 1 to 47 characters.
ip-address: IP address of a peer.
as-number: Local autonomous system number, in the range 1 to 65535.
Description
Use the peer fake-as command to configure a fake local AS number for a peer or peer
group.
Use the undo peer fake-as command to remove the configuration.
By default, no fake local AS number is configured for a peer or peer group.
 Note:
The peer fake-as command is only applicable to an EBGP peer or peer group.
Examples
# In BGP view, configure a fake AS number of 200 for the peer group test.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] peer test fake-as 200
5.1.52 peer filter-policy
Syntax
peer { group-name | ip-address } filter-policy acl-number { export | import }
undo peer { group-name | ip-address } filter-policy [ acl-number ] { export | import }
View
BGP view
Parameters
group-name: Name of a peer group, a string of 1 to 47 characters.
ip-address: IP address of a peer.
acl-number: ACL number, in the range 2000 to 3999.
export: Applies the filter-policy to routes advertised to the peer/peer group.
import: Applies the filter-policy to routes received from the peer/peer group.