Command Manual – 802.1x - MAC Authentication
H3C S7500E Series Ethernet Switches Chapter 1 802.1x Configuration Commands
1-16
[Sysname] dot1x supp-proxy-check logoff interface Ethernet2/0/1 to
Ethernet2/0/8
# Configure port Ethernet 2/0/9 to send a trap packet when detecting that a user is
trying to login through a proxy.
<Sysname> system-view
[Sysname] dot1x supp-proxy-check trap
[Sysname] dot1x supp-proxy-check trap interface Ethernet2/0/9
Or
<Sysname> system-view
[Sysname] dot1x supp-proxy-check trap
[Sysname] interface Ethernet2/0/9
[Sysname-Ethernet2/0/9] dot1x supp-proxy-check trap
1.1.13 dot1x timer
Syntax
dot1x timer { handshake-period handshake-period-value | quiet-period
quiet-period-value | server-timeout server-timeout-value | supp-timeout
supp-timeout-value | tx-period tx-period-value }
undo dot1x timer { handshake-period | quiet-period | server-timeout |
supp-timeout | tx-period }
View
System view
Parameters
handshake-period-value: Setting for the handshake timer in seconds. It ranges from 5
to 1024 and defaults to 15.
quiet-period-value: Setting for the quiet timer in seconds. It ranges from 10 to 120 and
defaults to 60.
server-timeout-value: Setting for the server timeout timer in seconds. It ranges from
100 to 300 and defaults to 100.
supp-timeout-value: Setting for the supplicant timeout timer in seconds. It ranges from
10 to 120 and defaults to 30.
tx-period-value: Setting for the username request timeout timer in seconds. It ranges
from 10 to 120 and defaults to 30.
Description
Use the dot1x timer command to set 802.1x timers.
Use the undo dot1x timer command to restore the defaults.
To Next Page
Loading...
Need help?
General
