Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 5 BGP Configuration Commands
5-21
Field Description
Origin attribute of the route, one of the following values:
i
Indicates that the route is interior to the AS.
Summary routes and the routes configured using the
network command are considered IGP routes.
e
Indicates that the route is learned via the exterior gateway
protocol (EGP).
Ogn
?
Short for INCOMPLETE. It indicates that the origin of the
route is unknown and the route is learned by other means.
5.1.21 display bgp routing-table as-path-acl
Syntax
display bgp routing-table as-path-acl as-path-acl-number
View
Any view
Parameters
as-path-acl-number: Displays routing information permitted by the AS path ACL, which
is specifies with a number from 1 to 256.
Description
Use the display bgp routing as-path-acl command to display BGP routes permitted
by an as-path ACL.
Examples
# Display BGP routes permitted by AS path ACL 1.
<Sysname> display bgp routing-table as-path-acl 1
BGP Local router ID is 20.20.20.1
Status codes: * - valid, > - best, d - damped,
h - history, i - internal, s - suppressed, S - Stale
Origin : i - IGP, e - EGP, ? - incomplete
Network NextHop MED LocPrf PrefVal Path/Ogn
*> 40.40.40.0/24 30.30.30.1 0 0 300i
Refer to Table 5-6 for description on the fields above.
To Next Page
Loading...
Need help?
General
