H3C S7500E Series Command Manual

Command Manual – File System Management
H3C S7500E Series Ethernet Switches Chapter 2 FTP Configuration Commands
2-5
2.2 FTP Client Configuration Commands
 Note:
z The prompt information in this section is that in the network where the H3C S7500E
series Ethernet switches act as the FTP server. If you use other devices as the FTP
server, PC for example, the prompt information may be different.
z You must use the ftp command to enter FTP client view for configurations under this
view. For details, refer to
ftp.
2.2.1 ascii
Syntax
ascii
View
FTP client view
Parameters
None
Description
Use the ascii command to set the file transfer mode to ASCII for the FTP connection.
FTP provides two file transfer modes: ASCII and binary. To transfer text files, use the
ASCII mode; to transfer program files, use the binary mode.
By default, the file transfer mode is ASCII.
Examples
# Set the file transfer mode to ASCII.
[ftp]ascii
200 Type set to A.
2.2.2 binary
Syntax
binary
View
FTP client view

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English