H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 4 PIM Configuration Commands
4-44
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim timer join-prune 80
4.1.49 pim triggered-hello-delay
Syntax
pim triggered-hello-delay interval
undo pim trigged-hello-delay
View
Interface view
Parameters
interval: Maximum delay in seconds between hello messages, with an effective range
of 1 to 5.
Description
Use the pim triggered-hello-delay command to configure the maximum delay
between hello messages.
Use the undo pim triggered-hello-delay command to restore the system default.
By default, the maximum delay between hello messages is 5 seconds.
Examples
# Set the maximum delay between hello messages to 3 seconds on VLAN-interface
100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim trigged-hello-delay 3
4.1.50 probe-interval
Syntax
probe-interval interval
undo probe-interval
View
PIM view
Parameters
interval: Probe time in seconds, with an effective range of 1 to 3,600.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English