H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 4 PIM Configuration Commands
4-20
Field Description
PIM require generation ID
Rejection of Hello messages without
Generation_ID (enabled/disabled)
PIM hello hold interval PIM neighbor timeout time
PIM assert hold interval Assert timeout time
PIM triggered hello delay
Maximum delay of sending hello
messages
PIM J/P interval Join/prune interval
PIM J/P hold interval Join/prune timeout time
PIM BSR domain border
BSR administrative scoping status
(enabled/disabled)
Number of routers on network not using
DR priority
Number of routers not using the DR
priority field on the subnet where the
interface resides
Number of routers on network not using
LAN delay
Number of routers not using the LAN
delay field on the subnet where the
interface resides
Number of routers on network not using
neighbor tracking
Number of routers not using neighbor
tracking on the subnet where the
interface resides
4.1.20 display pim join-prune
Syntax
display pim join-prune mode { sm [ flags flag-value ] | ssm } [ interface
interface-type interface-number | neighbor neighbor-address ] * [ verbose ]
View
Any view
Parameters
mode: Displays the information of join/prune messages to send in the specified PIM
mode. PIM modes include sm and ssm, which represent PIM-SM and PIM-SSM
respectively.
flags flag-value: Displays routing entries containing the specified flag. Values and
meanings of flag-value are as follows:
z rpt: Specifies routing entries on the RPT.
z spt: Specifies routing entries on the SPT.
z wc: Specifies wildcard routing entries.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English