H3C S7500E Series Command Manual

Command Manual – IP Routing Overview
H3C S7500E Series Ethernet Switches Chapter 1 Routing Overview Commands
1-19
Parameters
acl6-number: Basic IPv6 ACL number, in the range 2000 to 2999.
verbose: Displays both active and inactive verbose routing information permitted by
the ACL. Without this keyword, only brief active routing information is displayed.
Description
Use the display ipv6 routing-table acl command to display routing information
permitted by the IPv6 ACL.
If the specified IPv6 ACL is not available, all routing information is displayed.
Examples
# Display brief routing information permitted by ACL 2000.
<Sysname> display ipv6 routing-table acl 2000
Routes Matched by Access list 2000 :
Summary Count : 2
Destination : ::1/128 Protocol : Direct
NextHop : ::1 Preference : 0
Interface : InLoop0 Cost : 0
Destination : 1:1::/64 Protocol : Static
NextHop : :: Preference : 60
Interface : NULL0 Cost : 0
Refer to Table 1-9 for description about the above output.
1.1.13 display ipv6 routing-table ipv6-address
Syntax
display ipv6 routing-table ipv6-address prefix-length [ longer-match ] [ verbose ]
View
Any view
Parameters
ipv6-address: Destination IPv6 address.
prefix-length: Prefix length, in the range 0 to 128.
longer-match: Displays the matched route having the longest prefix length.
verbose: Displays both active and inactive verbose routing information. Without this
keyword, only brief active routing information is displayed.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English