H3C S7500E Series Command Manual

Command Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches Chapter 1 IPv6 Basics Configuration Commands
1-23
Examples
# Configure the IPv6 address 2002::1 for a DNS server.
<Sysname> system-view
[Sysname] dns server ipv6 2002::1
1.1.15 ipv6
Syntax
ipv6
undo ipv6
View
System view
Parameters
None
Description
Use the ipv6 command to enable the IPv6 packet forwarding function.
Use the undo ipv6 command to disable the IPv6 packet forwarding function.
By default, the IPv6 packet forwarding function is disabled.
Examples
# Enable the IPv6 packet forwarding function.
<Sysname> system-view
[Sysname] ipv6
1.1.16 ipv6 address
Syntax
ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length }
undo ipv6 address [ ipv6-address prefix-length | ipv6-address/prefix-length ]
View
Interface view
Parameters
ipv6-address: IPv6 address.
prefix-length: Prefix length of an IPv6 address, in the range 1 to 128.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English