H3C S7500E Series

To Next Page

To Previous Page

Command Manual – HA

H3C S7500E Series Ethernet Switches Table of Contents

Table of Contents

Chapter 1 VRRP Configuration Commands ............................................................................... 1-1

1.1 IPv4-Based VRRP Configuration Commands ................................................................... 1-1

1.1.1 display vrrp.............................................................................................................. 1-1

1.1.2 display vrrp statistics ............................................................................................... 1-3

1.1.3 reset vrrp statistics .................................................................................................. 1-5

1.1.4 vrrp vrid authentication-mode.................................................................................. 1-6

1.1.5 vrrp method ............................................................................................................. 1-7

1.1.6 vrrp ping-enable ...................................................................................................... 1-8

1.1.7 vrrp un-check ttl....................................................................................................... 1-8

1.1.8 vrrp vrid preempt-mode........................................................................................... 1-9

1.1.9 vrrp vrid priority...................................................................................................... 1-10

1.1.10 vrrp vrid timer advertise....................................................................................... 1-11

1.1.11 vrrp vrid track....................................................................................................... 1-11

1.1.12 vrrp vrid virtual-ip................................................................................................. 1-12

1.2 VRRP Configuration Commands for IPv6 ....................................................................... 1-13

1.2.1 display vrrp ipv6 .................................................................................................... 1-13

1.2.2 display vrrp ipv6 statistics ..................................................................................... 1-16

1.2.3 reset vrrp ipv6 statistics......................................................................................... 1-18

1.2.4 vrrp ipv6 vrid authentication-mode........................................................................ 1-18

1.2.5 vrrp ipv6 method.................................................................................................... 1-19

1.2.6 vrrp ipv6 ping-enable............................................................................................. 1-20

1.2.7 vrrp ipv6 vrid preempt-mode ................................................................................. 1-21

1.2.8 vrrp ipv6 vrid priority.............................................................................................. 1-22

1.2.9 vrrp ipv6 vrid timer advertise.................................................................................1-23

1.2.10 vrrp ipv6 vrid track............................................................................................... 1-23

1.2.11 vrrp ipv6 vrid virtual-ip.........................................................................................1-24

Chapter 2 HA Configuration Commands ....................................................................................2-1

2.1 HA Configuration Commands............................................................................................ 2-1

2.1.1 display switchover state .......................................................................................... 2-1

2.1.2 ha slave-ignore-version-check ................................................................................ 2-2

2.1.3 slave auto-update config......................................................................................... 2-2

2.1.4 slave restart............................................................................................................. 2-3

2.1.5 slave switchover...................................................................................................... 2-3

2.1.6 slave switchover { enable | disable } ....................................................................... 2-4

Other manuals for H3C S7500E Series