To Next Page

To Previous Page

Command Manual – QoS

H3C S7500E Series Ethernet Switches Chapter 2 QoS Policy Configuration Commands

2-13

Description

Use the remark dot1p command to configure the action of setting 802.1p precedence

for a traffic behavior.

Use the undo remark dot1p command to remove the action of setting 802.1p

precedence

Note that, when the remark dot1p command is used together with the remark

local-precedence command, the 802.1p precedence to be set for packets must be the

same as the local precedence to be set for packets. Otherwise, the corresponding

policy cannot be applied successfully..

Related commands: qos policy, traffic behavior, classifier behavior.

Examples

# Configure the action to set 802.1p precedence to 2 for a traffic behavior.

<Sysname> system-view

[Sysname] traffic behavior database

[Sysname-behavior-database] remark dot1p 2

2.2.9 remark drop-precedence

Syntax

remark drop-precedence drop-precedence-value

undo remark drop-precedence

View

Traffic behavior view

Parameters

drop-precedence-value: Drop precedence to be set for packets, in the range 0 to 2.

Description

Use the remark drop-precedence command to configure the action of setting drop

precedence for a traffic behavior.

Use the undo remark drop-precedence command to remove the action of setting

drop precedence.

Related commands: qos policy, traffic behavior, classifier behavior.

Examples

# Configure the action to set drop precedence to 2 for a traffic behavior.

<Sysname> system-view

[Sysname] traffic behavior database

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series