H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 5 BGP Configuration Commands
5-26
Field Description
HalfLife Time Half-life time of active routes
Suppress-Limit Limit for a route to be suppressed
5.1.27 display bgp routing-table different-origin-as
Syntax
display bgp routing-table different-origin-as
View
Any view
Parameters
None
Description
Use the display bgp routing-table different-origin-as command to display BGP
routes originating from different autonomous systems.
Examples
# Display BGP routes originating from different ASs.
<Sysname> display bgp routing-table different-origin-as
BGP Local router ID is 2.2.2.2
Status codes: * - valid, > - best, d - damped,
h - history, i - internal, s - suppressed, S - Stale
Origin : i - IGP, e - EGP, ? - incomplete
Network NextHop MED LocPrf PrefVal Path/Ogn
*> 55.0.0.0 12.1.1.1 0 0 100?
* 14.1.1.2 0 0 300?
Refer to Table 5-6 for description on the fields above.
5.1.28 display bgp routing-table flap-info
Syntax
display bgp routing-table flap-info [ regular-expression as-regular-expression |
as-path-acl as-path-acl-number | ip-address [ { mask | mask-length }
[ longer-match ] ] ]