H3C S7500E Series Command Manual

Command Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches Chapter 1 IPv6 Basics Configuration Commands
1-37
Examples
# Set the maximum number of neighbors that can be dynamically learned on
VLAN-interface 100 to 10.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 neighbors max-learning-num 10
1.1.35 ipv6 pathmtu
Syntax
ipv6 pathmtu ipv6-address [ value ]
undo ipv6 pathmtu ipv6-address
View
System view
Parameters
ipv6-address: Specified IPv6 address.
value: PMTU of a specified IPv6 address in bytes. The value range and the default
value vary with devices. It ranges from 1280 to 10000.
Description
Use the ipv6 pathmtu command to configure a static PMTU for a specified IPv6
address.
Use the undo ipv6 pathmtu command to remove the PMTU configuration for a
specified IPv6 address.
By default, no static PMTU is configured.
Examples
# Configure a static PMTU for a specified IPv6 address.
<Sysname> system-view
[Sysname] ipv6 pathmtu fe80::12 1300
1.1.36 ipv6 pathmtu age
Syntax
ipv6 pathmtu age age-time
undo ipv6 pathmtu age

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English