H3C S7500E Series Command Manual

Command Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches Chapter 2 Dual Stack Configuration Commands
2-1
Chapter 2 Dual Stack Configuration Commands
2.1 Dual Stack Configuration Commands
2.1.1 ipv6
Syntax
ipv6
undo ipv6
View
System view
Parameters
None
Description
Use the ipv6 command to enable the IPv6 packet forwarding function.
Use the undo ipv6 command to disable the IPv6 packet forwarding function.
By default, the function is disabled.
Examples
# Enable the IPv6 packet forwarding function.
<Sysname> system-view
[Sysname] ipv6
2.1.2 ipv6 address
Syntax
ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length }
undo ipv6 address [ ipv6-address prefix-length | ipv6-address/prefix-length ]
View
Interface view
Parameters
ipv6-address: IPv6 address for the interface.
prefix-length: Length of the prefix in bits, in the range of 1 to 128.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English