H3C S7500E Series Command Manual

Command Manual – VLAN
H3C S7500E Series Ethernet Switches Chapter 4 GARP/GVRP Configuration Commands
4-8
4.2.4 display gvrp status
Syntax
display gvrp status
View
Any view
Parameters
None
Description
Use the display gvrp status command to display the global enable/disable state of
GVRP.
Examples
# Display the global GVRP enable/disable state.
<Sysname> display gvrp status
GVRP is enabled
4.2.5 display gvrp vlan-operation interface
Syntax
display gvrp vlan-operation interface interface-type interface-number
View
Any view
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Description
Use the display gvrp vlan-operation interface command to display the information
about dynamic VLAN operations performed on a port.
Examples
# Display the information about dynamic VLAN operations performed on Ethernet
2/0/1.
<Sysname> display gvrp vlan-operation interface ethernet 2/0/1
Dynamic VLAN operations on port Ethernet2/0/1

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English