H3C S7500E Series Command Manual

Command Manual – NTP
H3C S7500E Series Ethernet Switches Chapter 1 NTP Configuration Commands
1-10
View
VLAN interface view
Parameters
None
Description
Use the ntp-service in-interface disable command to disable an interface from
receiving NTP messages.
Use the undo ntp-service in-interface disable command to restore the default.
By default, all interfaces are enabled to receive NTP messages.
Examples
z On an Ethernet interface:
# Disable interface Ethernet 2/0/1 from receiving NTP messages.
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] ntp-service in-interface disable
z On a VLAN interface:
# Disable VLAN-interface 1 from receiving NTP messages.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] ntp-service in-interface disable
1.1.10 ntp-service max-dynamic-sessions
Syntax
ntp-service max-dynamic-sessions number
undo ntp-service max-dynamic-sessions
View
System view
Parameters
number: Maximum number of dynamic NTP sessions that allowed to be established, in
the range of 0 to 100.
Description
Use the ntp-service max-dynamic-sessions command to set the maximum number
of dynamic NTP sessions that allowed to be established locally.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English