Command Manual – VLAN
H3C S7500E Series Ethernet Switches Chapter 1 VLAN Configuration Commands
1-11
[Sysname-Ethernet2/0/1] port hybrid pvid vlan 100
1.2.4 port hybrid vlan
Syntax
port hybrid vlan vlan-id-list { tagged | untagged }
undo port hybrid vlan vlan-id-list
View
Ethernet port view, port group view
Parameters
vlan-id-list: The range of VLANs that the Hybrid ports will be added to, vlan-id-list =
[ vlan-id1 [ to vlan-id2 ] ]&<1-10>, where vlan-id ranges from 1 to 4,094 and &<1-10>
indicates that the you can specify up to 10 times.
tagged: Specifies to tag the packets of the specified VLAN (s).
untagged: Specifies not to tag the specified VLAN(s).
Description
Use the port hybrid vlan command to add the current Hybrid port to the specified
VLAN(s).
Use the undo port hybrid vlan command to remove the current Hybrid port from the
specified VLAN(s).
The Hybrid port can allow multiple VLANs to pass. Repetitive execution of the port
hybrid vlan command will yield a set VLANs, to which the Hybrid port belongs.
Execution of the above commands in Ethernet port view will apply to the current port
only whereas under port group view will apply to all ports in the port group.
Related commands: port link-type.
Examples
# Add the Hybrid port Ethernet 2/0/1 to VLAN 2, VLAN 4, and the range of VLANs from
VLAN 50 to VLAN 100. Tag all packets of these VLANs.
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] port link-type hybrid
[Sysname-Ethernet2/0/1] port hybrid vlan 2 4 50 to 100 tagged
# Add Hybrid ports of port group 2 to VLAN 2. Packets are untagged.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] quit
To Next Page
Loading...
Need help?
General
