H3C S7500E Series Command Manual

Command Manual – System Maintaining and Debugging
H3C S7500E Series Ethernet Switches Chapter 3 Device Management Commands
3-26
 Note:
To make the configured forwarding mode take effect, you need to save the
configuration and restart the switch.
Examples
# Configure the traffic forwarding mode of the SRPU (LSQ1MPUA) as the enhanced
Layer 2 forwarding mode.
<Sysname> system-view
[Sysname] switch-mode l2-enhanced
# Restore the default traffic forwarding mode of the SRPU.
<Sysname> system-view
[Sysname] undo switch-mode
3.1.23 switch-mode (for LPU)
Syntax
switch-mode { bridging | routing } slot slot-num
undo switch-mode slot slot-num
View
System view
Parameters
bridging: Indicates the MAC extension mode.
routing: Indicates the route extension mode.
slot-num: Number of the slot where the LPU resides.
Description
Use the switch-mode command to configure the working mode of an EA LPU.
Use the undo switch-mode command to restore the default working mode of the EA
LPU.
By default, the working mode of an EA LPU is determined by the SRPU model and the
current traffic forwarding mode of the SRPU. Refer to
Table 3-12 for details.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English