To Next Page

To Previous Page

Command Manual – IPv6 Configuration

H3C S7500E Series Ethernet Switches Chapter 3 Tunneling Configuration Commands

3-7

3.1.6 mtu (tunnel interface view)

Syntax

mtu mtu-size

undo mtu

View

Tunnel interface view

Parameters

mtu-size: Tunnel interface MTU in bytes, in the range of 100 to 64,000.

Description

Use the mtu command to configure the tunnel interface MTU.

Use the undo mtu command to restore the default tunnel interface MTU.

Examples

# Set the tunnel interface MTU to 10,000 bytes.

<Sysname> system-view

[Sysname] interface tunnel 1/0/3

[Sysname-Tunnel1/0/3] mtu 10000

3.1.7 source

Syntax

source { ip-address | interface-type interface-number }

undo source

View

Tunnel interface view

Parameters

ip-address: Tunnel source IPv4 address.

interface-type interface-number: Specifies an interface. The interface types include

Vlan-interface, tunnel, and so on.

Description

Use the source command to specify the source address for the tunnel interface.

Use the undo source command to remove the configured tunnel source address.

By default, no tunnel source address is configured.

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series