Command Manual – Multicast
H3C S7500E Series Ethernet Switches
Chapter 6 Multicast Routing and Forwarding
Configuration Commands
6-9
6.1.6 ip rpf-route-static
Syntax
ip rpf-route-static source-address { mask | mask-length } [ protocol [ process-id ] ]
[ route-policy policy-name ] { rpf-nbr-address | interface-type interface-number }
[ preference preference ] [ order order-number ]
undo ip rpf-route-static source-address { mask | mask-length } [ protocol
[ process-id ] ] [ route-policy policy-name ]
View
System view
Parameters
source-address: Multicast source address.
mask: Mask of the multicast source address.
mask-length: Mask length of the multicast source address, in the range of 0 to 32.
protocol: Routing protocol, which can have any of the following values:
z bgp: Specifies the BGP protocol.
z isis: Specifies the IS-IS protocol.
z ospf: Specifies the OSPF protocol.
z rip: Specifies the RIP protocol.
process-id: Process number of the unicast routing protocol, in the range of 1 to 65535.
This argument must be provided if IS-IS, OSPF or RIP is the specified unicast routing
protocol.
policy-name: Name of the multicast route match rule, a string of 1 to 19 characters.
rpf-nbr-address: Specifies an RPF neighbor by the IP address.
interface-type interface-number: Specifies an RPF neighbor by the interface type and
interface number. The interface type must not be Ethernet, GigabitEthernet, Loopback
or VLAN-interface.
preference: Route preference, in the range of 1 to 255 and defaulting to 1.
order-number: Match order for routes on the same segment, in the range of 1 to 100.
Description
Use the ip rpf-route-static command to configure a multicast static route.
Use the undo ip rpf-route-static command to delete a multicast static route from the
multicast static routing table.
By default, no multicast static route is configured.
Note that:
To Next Page
Loading...
Need help?
General
