Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 1 IGMP Snooping Configuration Commands
1-12
z If you do not specify any VLAN in Ethernet interface view, the command will take
effect on the port no matter which VLAN the port belongs to; if you specify a VLAN
or multiple VLANs, the command will take effect on the port only if the port belongs
to the specified VLAN(s).
z If you do not specify any VLAN in port group view, the command will take effect on
all the ports in this group no matter which VLANs these ports belong to; if you
specify a VLAN or multiple VLANs, the command will take effect on those ports in
this group that belong to the specified VLAN(s).
Examples
# Specify to allow a maximum of 10 multicast groups to be joined on Ethernet 2/0/1,
which belongs to VLAN 2.
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] igmp-snooping group-limit 10 vlan 2
1.1.13 igmp-snooping group-policy
Syntax
igmp-snooping group-policy acl-number [ vlan vlan-list ]
undo igmp-snooping group-policy [ vlan vlan-list ]
View
Ethernet interface view, port group view
Parameters
acl-number: Basic ACL number, in the range of 2000 to 2999.
vlan vlan-list: Defines one or multiple VLANs. You can provide up to 10 VLAN lists, by
each of which you can specify an individual VLAN in the form of vlan-id, or a VLAN
range in the form of start-vlan-id to end-vlan-id, where the end VLAN ID must be
greater than the start VLAN ID. The effective range of a VLAN ID is 1 to 4094.
Description
Use the igmp-snooping group-policy command to configure a multicast group filter
on the current port(s).
Use the undo igmp-snooping group-policy command to remove a multicast group
filter on the current port(s).
Be default, no multicast group filter is configured on an interface, namely a host can join
any multicast group
Note that: