H3C S7500E Series

Command Manual – RRPP
H3C S7500E Series Ethernet Switches Chapter 1 RRPP Configuration Commands
1-2
1.1.2 display rrpp brief
Syntax
display rrpp brief
View
Any view
Parameters
None
Description
Use the display rrpp brief command to display the brief information of RRPP
configuration.
Examples
# Display the brief information of RRPP configuration.
<Sysname> display rrpp brief
Flags for Node Mode :
M –- Master , T -- Transit , E -- Edge , A -- Assistant-Edge
RRPP Protocol Status: Enable
Number of RRPP Domains: 2
Domain ID : 1
Control VLAN : Major 5 Sub 6
Hello Timer : 1 sec Fail Timer : 3 sec
Ring Ring Node Primary/Common Secondary/Edge Enable
ID Level Mode Port Port Status
-------------------------------------------------------------------------
1 1 M GigabitEthernet3/0/1 GigabitEthernet3/0/2 Yes
Domain ID : 2
Control VLAN : Major 10 Sub 11
Hello Timer : 1 sec Fail Timer : 3 sec
Ring Ring Node Primary/Common Secondary/Edge Enable
ID Level Mode Port Port Status
-------------------------------------------------------------------------
1 0 M GigabitEthernet3/0/3 GigabitEthernet3/0/4 Yes