Command Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches Chapter 1 IPv6 Basics Configuration Commands
1-10
Description
Use the display ipv6 neighbors count command to display the total number of
neighbor entries satisfying the specified condition.
Examples
# Display the total number of neighbor entries acquired dynamically.
<Sysname> display ipv6 neighbors dynamic count
Total dynamic entry(ies): 2
1.1.8 display ipv6 pathmtu
Syntax
display ipv6 pathmtu { ipv6-address | all | dynamic | static }
View
Any view
Parameters
ipv6-address: IPv6 address whose PMTU information is to be displayed.
all: Displays all PMTU information.
dynamic: Displays all dynamic PMTU information.
static: Displays all static PMTU information.
Description
Use the display ipv6 pathmtu command to display the PMTU information of IPv6
addresses.
Examples
# Display all PMTU information.
<Sysname> display ipv6 pathmtu all
IPv6 Destination Address ZoneID PathMTU Age Type
fe80::12 0 1300 40 Dynamic
2222::3 0 1280 - Static
Table 1-8 Description on fields of the display ipv6 pathmtu command
Field Description
IPv6 Destination Address Destination IPv6 address
ZoneID ID of address zone, currently invalid
PathMTU PMTU of an IPv6 address
To Next Page
Loading...
Need help?
General
