H3C S7500E Series Command Manual

Command Manual – Port Correlation Configuration
H3C S7500E Series Ethernet Switches
Chapter 1 Ethernet Port Configuration
Commands
1-29
corresponding threshold or the traffic drops down below the lower threshold after
exceeding the upper threshold.
Use the undo storm-constrain enable log command to disable log sending.
By default, log sending is enabled.
Examples
# Disable log sending for Ethernet 2/0/1.
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] undo storm-constrain enable log
1.1.29 storm-constrain enable trap
Syntax
storm-constrain enable trap
undo storm-constrain enable trap
View
Ethernet port view
Parameters
None
Description
Use the storm-constrain enable trap command to enable trap message sending.
With trap message sending enabled, the system sends trap messages when traffic
reaching a port exceeds the corresponding threshold or the traffic drops down below
the lower threshold after exceeding the upper threshold.
Use the undo storm-constrain enable trap command to disable trap message
sending.
By default, trap message sending is enabled.
Examples
# Disable trap message sending on Ethernet 2/0/1.
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] undo storm-constrain enable trap

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English