Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Chapter 1 AAA/RADIUS/HWTACACS
Configuration Commands
1-12
Parameters
hwtacacs-scheme hwtacacs-scheme-name: Specifies an HWTACACS scheme by its
name, which is a string of 1 to 32 characters.
Description
Use the authorization command command to specify the authorization scheme for
command line users.
Use the undo authorization command command to restore the default.
By default, the default authorization scheme is used for command line users.
Note that the HWTACACS scheme specified for the current ISP domain must have
been configured.
Related commands: authorization default, hwtacacs scheme.
Examples
# Configure the default ISP domain system to use HWTACACS authorization scheme
hw for command line users.
<Sysname> system-view
[Sysname] domain system
[Sysname-isp-system] authorization command hwtacacs-scheme hw
1.1.13 authorization default
Syntax
authorization default { hwtacacs-scheme hwtacacs-scheme-name [ local ] | local |
none | radius-scheme radius-scheme-name [ local ] }
undo authorization default
View
ISP domain view
Parameters
hwtacacs-scheme hwtacacs-scheme-name: Specifies an HWTACACS scheme by its
name, which is a string of 1 to 32 characters.
local: Performs local authorization.
none: Does not perform any authorization. In this case, an authenticated user is
automatically authorized with the default right.
radius-scheme radius-scheme-name: Specifies a RADIUS scheme by its name, which
is a string of 1 to 32 characters.
To Next Page
Loading...
Need help?
General
