To Next Page

To Previous Page

Command Manual – IPv4 Routing

H3C S7500E Series Ethernet Switches Chapter 2 RIP Configuration Commands

2-6

10.0.0.0/8, cost 1, ClassfulSumm

10.0.0.0/24, cost 1, nexthop 10.0.0.1, Rip-interface

11.0.0.0/8, cost 1, ClassfulSumm

11.0.0.0/24, cost 1, nexthop 10.0.0.1, Imported

Table 2-2 Description on fields of the display rip database command

Field Description

X.X.X.X/X Destination address and subnet mask

cost Cost of the route

classful-summ Indicates the route is a RIP summary route.

Nexthop Address of the next hop

Rip-interface Routes learnt from a RIP–enabled interface

imported Routes redistributed from other routing protocols

2.1.6 display rip interface

Syntax

display rip process-id interface [ interface-type interface-number ]

View

Any view

Parameters

process-id: RIP process ID, in the range of 1 to 65535.

interface-type interface-number: Specifies an interface.

Description

Use the display rip interface command to display the RIP interface information of the

RIP process.

If no interface is specified, information about all RIP interfaces of the RIP process is

displayed.

Examples

# Display all the interface information of RIP process 1.

<Sysname> display rip 1 interface

Interface-name: Vlan-interface1

Address/Mask:1.1.1.1/24 MetricIn/Out:0/1 Version: RIPv1

Split-horizon/Poison-reverse:on/off Input/Output:on/on

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series