To Next Page

To Previous Page

Command Manual – HA

H3C S7500E Series Ethernet Switches Chapter 1 VRRP Configuration Commands

1-7

z You may configure different authentication types and authentication keys for the

standby groups on an interface. However, the members of the same standby

group must use the same authentication mode and authentication key.

Examples

# Set the authentication mode and authentication key for VRRP standby group 1 on

interface VLAN-interface 2 to send and receive VRRP packets.

<Sysname> system-view

[Sysname] interface vlan-interface 2

[Sysname-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.1

[Sysname-Vlan-interface2] vrrp vrid 1 authentication-mode simple Sysname

1.1.5 vrrp method

Syntax

vrrp method { real-mac | virtual-mac }

undo vrrp method

View

System view

Parameters

real-mac: Associates the real MAC address of the interface with the virtual IP address

of the standby group.

virtual-mac: Associates the virtual MAC address of the switch with the virtual IP

address of the standby group.

Description

Use the vrrp method command to set the mappings between the virtual IP addresses

and the MAC addresses of the standby groups.

Use the undo vrrp method command to restore the default mapping.

By default, the virtual MAC address of the standby group is associated with the virtual

IP address.

You must configure the mapping between the virtual IP address and the MAC address

before configuring a standby group. Otherwise, your configuration will fail.

Examples

# Associate the virtual IP address of the standby group with the real MAC address of

the routing interface.

<Sysname> system-view

[Sysname] vrrp method real-mac

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series