Command Manual – Information Center
H3C S7500E Series Ethernet Switches
Chapter 1 Information Center Configuration
Commands
1-19
View
System view
Parameters
channel-number: Specifies a channel number, in the range 0 to 9.
channel-name: Specifies a channel name, which could be a default name or a
self-defined name. The user needs to specify a channel name first before using it as a
self-defined channel name. For more information, refer to the info-center channel
name command.
Description
Use the info-center monitor channel command to configure the channel to output
system information to the monitor.
Use the undo info-center monitor channel command to restore the default channel
to output system information to the monitor.
By default, output of system information to the monitor is enabled with a default channel
name of monitor and a default channel number of 1.
Note that the info-center monitor channel command takes effect only after the
information center is enabled with the info-center enable command.
Examples
# Set to output system information to the monitor through channel 0.
<Sysname> system-view
[Sysname] info-center monitor channel 0
1.1.19 info-center snmp channel
Syntax
info-center snmp channel { channel-number | channel-name }
undo info-center snmp channel
View
System view
Parameters
channel-number: Specifies a channel number, in the range 0 to 9.
channel-name: Specifies a channel name, which could be a default name or a
self-defined name. The user needs to specify a channel name first before using it as a
self-defined channel name. For more information, refer to the info-center channel
name command.
To Next Page
Loading...
Need help?
General
