H3C S7500E Series

Command Manual – IP Routing Overview
H3C S7500E Series Ethernet Switches Chapter 1 Routing Overview Commands
1-21
Summary Count : 1
Destination: 10::/120 Protocol : Static
NextHop : :: Preference: 60
Interface : NULL0 Cost : 0
Refer to Table 1-9 for description about the above output.
1.1.14 display ipv6 routing-table ipv6-address1 ipv6-address2
Syntax
display ipv6 routing-table ipv6-address1 prefix-length1 ipv6-address2 prefix-length2
[ verbose ]
View
Any view
Parameters
ipv6-address1/ipv6-address2: An IPv6 address range from IPv6 address1 to IPv6
address2.
prefix-length1/prefix-length2: Prefix length, in the range 0 to 128.
verbose: Displays both active and inactive verbose routing information. Without this
keyword, only brief active routing information is displayed.
Description
Use the display ipv6 routing-table ipv6-address1 ipv6-address2 command to display
routes with destinations falling into the specified IPv6 address range.
Examples
# Display routes with destinations falling into the IPv6 address range.
<Sysname> display ipv6 routing-table 100:: 64 400:: 64
Routing Table :
Summary Count : 3
Destination: 100::/64 Protocol : Static
NextHop : 1::2 Preference: 60
Interface : Vlan1 Cost : 0
Destination: 200::/64 Protocol : Static
NextHop : 1::2 Preference: 60
Interface : Vlan1 Cost : 0