H3C S7500E Series

Command Manual – VLAN
H3C S7500E Series Ethernet Switches Chapter 2 Isolate-User-VLAN Configuration Commands
2-1
Chapter 2 Isolate-User-VLAN Configuration
Commands
2.1 Isolate-User-VLAN Configuration Commands
2.1.1 display isolate-user-vlan
Syntax
display isolate-user-vlan [ isolate-user-vlan-id ]
View
Any view
Parameters
isolate-user-vlan-id: VLAN ID of an isolate-user-VLAN, in the range 1 to 4094.
Description
Use the display isolate-user-vlan command to display the mapping between an
isolate-user-vlan and the secondary VLAN(s).
Related commands: isolate-user-vlan, isolate-user-vlan enable.
Examples
# Display the mapping between an isolate-user-vlan and secondary VLANs.
<Sysname> display isolate-user-vlan
Isolate-user-VLAN VLAN ID : 2
Secondary VLAN ID : 3 4
VLAN ID: 2
VLAN Type: static
Isolate-user-VLAN type : isolate-user-VLAN
Route Interface: configured
IP Address: 1.1.1.1
Subnet Mask: 255.255.255.0
Description: VLAN 0002
Broadcast MAX-ratio: 100%
Tagged Ports: none
Untagged Ports:
Ethernet2/0/2 Ethernet2/0/3 Ethernet2/0/4