Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 5 BGP Configuration Commands
5-50
ip-address: IP address of a peer.
Description
Use the peer next-hop-local command to specify the router as the next hop for routes
to a peer/peer group.
Use the undo peer next-hop-local command to remove the configuration.
By default, routes advertised to an EBGP peer/peer group take the local router as the
next hop, while routes to an IBGP peer/peer group do not take the local router as the
next hop.
Examples
# In BGP view, set the next hop of routes advertised to peer group test to the router
itself.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] peer test next-hop-local
5.1.59 peer password
Syntax
peer { group-name | ip-address } password { cipher | simple } password
undo peer { group-name | ip-address } password
View
BGP view
Parameters
group-name: Name of a peer group, a string of 1 to 47 characters.
ip-address: IP address of a peer.
cipher: Displays the configured password in cipher text format.
simple: Displays the configured password in plain text format.
password: Password, a string of 1 to 80 characters when the simple keyword is used,
or when the cipher keyword and plain text password are used; a string of 108
characters when the cipher text password and the cipher keyword are used.
Description
Use the peer password command to configure BGP to perform MD5 authentication
when a TCP connection is being established with a peer/peer group.
Use the undo peer password command to disable the function.
By default, no MD5 authentication is performed for TCP connection establishment.
To Next Page
Loading...
Need help?
General
